Quilt Frame

Reposted with updated photos.
I have read so many blogs by quilters who are still crawling on the floor to layer and baste or pin their quilts. It is time to rise up off the floor and get yourself a quilt frame! I watched Footloose the other night Whether you find one at an estate sale or go to the lumber yard and buy boards to make one, a serious quilter needs a quilt frame.

 I have 2 quilting frames, this one was my Gramma's, the boards are 3/4 inch x 4 inches wide and are 86 and 101 inches long. It will frame up to a full size quilt. It has holes drilled every 4 inches, pieced strips of denim are nailed to each board for pinning the backing. The holes are for dropping large nails through to square the frame. Then she used C clamps to keep it tight.  Gramma used the frame to hand quilt. She would sit on one side and quilt as far as she could reach then remove pins and 2 nails and roll the quilt onto the board and then drop the nails through the holes again  and clamp with C clamps to keep the frame in place and the quilt taught on the frame. She had short stanchions with holes for the corner nails so the quilt was at a comfortable height for quilting.
The other quilt frame that I have belonged to the Grandmother of one of my dearest friends and if she ever starts quilting I will return it to her. It is made of 1 inch x 2 inch boards that are 96 inches and 120 inches long.

I set it on my dining chairs, a good height for pinning, its a little higher than kitchen counter tops. I put the nails in the holes then measure across and lengthwise at the corners and diagonally to be sure it is square.

Then I pin or staple the backing to the frame. Stapling is quicker to put on the frame but pinning in much quicker to take off and there is no scarring the fabric with pins.

Lay the batting on and smooth it out.

Lay quilt top on and smooth it out

I pin with straight pins if I plan to machine quilt it. I baste if I am going to hand quilt with my lap frame.

Buy boards that are knot free you don't want it oozing sap on your quilt.  And  don't let the guy at the lumber yard sell you warped or crooked boards that contractors have rejected. Straight boards are a must. Clamp or tape the boards together in pairs so you are drilling holes through both boards. Measure and mark every 4 inches. Then take your hubby's cordless drill and drill holes big enough to accommodate the 4 great big nails you bought with the boards.  Mine are mismatched 3 1/2 and 4 inch nails. If you are a pinner sew long strips of denim and fold in half then tack or staple to boards. If you prefer to staple quilts to the frame skip that step. Use a light weight staple gun  with 1/4 inch staples  you want them to come out easily. I tilt the staple gun slightly so the staple does not go in all the way and leaves a space to pry it out with a flat edge screw driver.

Save your knees! Save your back! Get a quilt frame! Sweet talk your hubby into one for Valentines Day or get him a cordless drill.

 Happy Quilting,

 Ann